TM 11-5895-1412-12&P
Enter the numbers and the following message appears:
Press REQUEST on fill device to begin transfer of N#.
Set the ECCM fill device to the desired position (1-13) and press the
REQUEST button on the ECCM fill device.
The following message appears:
Transfer Complete for Cell: #.
Watch for the red LED on the ECCM fill device to flash indicating a good
fill.
The flash should occur after a count of two.
Continue the process until all of the desired net lockouts are loaded.
If L7 and/or L8 are required, you are prompted to transfer them after
the corresponding net lockout.
3.
OPERATIONAL TRANSEC
Use this option to transfer the operational TRANSEC Key to the fill
device.
Select this option and the following message is displayed:
Press REQUEST on fill device to begin transfer of TRANSEC
Key l.
Set the ECCM fill device to the desired position (T1) and press the
REQUEST button on the ECCM fill device.
Watch for the red LED on the ECCM fill device to flash indicating a good
fill.
The flash should occur after a count of two.
4.
SPARE TRANSEC
Use this option to transfer the spare TRANSEC Key to the fill device.
Select this option and the following message is displayed:
Press REQUEST on fill device to begin transfer of TRANSEC
Key 2.
Set the ECCM fill device to the desired position (T2) and press the
REQUEST button on the ECCM fill device.
Watch for the red LED on the ECCM fill device to flash indicating a good
fill.
The flash should occur after a count of two.
c.
NON-ICOM SINCGARS DATA TO MX-18290
Use this option to transfer Non-ICOM SINCGARS data to a MX-18290. See Appendix
I.
2-109