Figure 2-92
TM 11-5895-1412-12&P
Zeroize the ECCM before transferring data from the BGU. To zeroize all
locations in the ECCM, set the Selector switch to “A”, press and hold the
REQUEST (Initiate) button and switch the Function switch to ZA then release.
After selecting <f4> from the screen shown in Figure 2-73, you are prompted to
enter the hopset data filename extension (2-digit tag number). Enter the
extension and press <RETURN>.
Next, the Transfer Menu screen shown in Figure 2-92 is displayed.
Figure 2-92 (XFER S0I/CE0I/f1, f4)
Use the help screen for descriptions of any function keys displayed on the
screen.
Completely loading an ECCM fill device takes about three to four minutes if no
mistakes are made.
CAUTION:
POWER TO INTERFACE must be turned on to communicate with the ECCM fill device
(see Entering Datacom Information, pages 2-9 and 2-10). The fill device must
be connected and turned on.
A.
ICOM SINCGARS DATA TO MX-18290
Use this option to transfer ICOM SINCGARS data to MX-18290. See Appendix J.
Select <f1> from Figure 2-92 and the Select TRANSEC Key screen is displayed as
shown in Figure 2-93.
NOTE:
Each TRANSEC Key selected equals two TRANSECS, an operational and a spare,
which are stored with ICOM and Non-ICOM parity.
2-104
