SAVE TO DISK

TM-11-5895-1412-12P Basic Generation Unit AN/GYK-33 (NSN 5895-01-260-4545) (EIC:N/A) Manual
Page Navigation
33

TM 11-5895-1412-12&P followed by: “REMOVE PROGRAM DISK FROM DRIVE C INSERT DATA DISK INTO DRIVE C“ Insert the data disk and press any key. A listing of the loaded files is shown and then the computer screen displays: “REMOVED DATADISK FROM DRIVE C INSERT PROGRAM DISK INTO DRIVE C“ Insert program disk and hit any key. The PAM menu comes to the screen. This PAM selection stores all BGU data to a data disk. THE DATA DISK MUST BE PROPERLY FORMATTED BEFORE ATTEMPTING TO STORE DATA. (See Format C Drive, page 2-17 for the procedures to format a disk.) Use this option at the end of each session to store all the data entered. Data created from a session is not stored until this option is used. Once this option is selected, the screen displays: Loading “SAVE TO DISK” followed by: “REMOVE PROGRAM DISK FROM DRIVE C INSERT DATA DISK INTO DRIVE C" Insert the data disk and press any key. A file listing of all files stored is displayed, followed by: “REMOVE DATA DISK FROM DRIVE C INSERT PROGRAM DISK INTO DRIVE C" Insert the program disk and press any key. The PAM menu comes to the screen and data is stored. Label each data disk before it is stored. Note: The disk’s label should contain the following: 1. A summary of the SOI/CEOI data contained on the disk 2. The hopset filename (if any) 3 . The TRANSEC Key pair name (i.e. TSK #1) 4 . The level at which all data was generated 5 . The date of generation or effective date or both 2-14

Privacy Statement
Press Release
Contact