HOPSET LOADING (LOCAL FILL)

TM-11-5895-1412-12P Basic Generation Unit AN/GYK-33 (NSN 5895-01-260-4545) (EIC:N/A) Manual
Page Navigation
244

TM 11-5895-1412-12&P c. Set rt controls: FCTN to LD and MODE d. Set ECCM fill device select switch to to FH. desired lockout set position. e. Set ECCM fill device function to ON. f. Press rt and after the beep press <Sto/ENT> g. To load more lockouts, reset fill device select switch and repeat rt keyboard steps. HOPSET LOADING (LOCAL FILL) a. Make sure rt CHAN is not set to CUE. b. Set ECCM fill device function switch to OFF; then connect fill cable to rt connector AUD/FILL and to fill device connector J1. c. Set rt controls: FCTN to LD and MODE to FH. d. Set ECCM fill device select switch to desired hopset position. e. Set ECCM fill device function to ON. f. Press rt After the beep press <Sto/ENT> and <CHANNEL/NUMBER/ (1-6)>. g. To load more hopsets, reset fill device select switch and repeat rt keyboard steps. After all required hopsets, lockout sets and TRANSEC variables are loaded, turn off and disconnect fill device. FH SYNC TIME [CHECKING AND SETTING] The FH sync time clock in your rt is used to time FH operations. This clock stops running when FCTN has been set to OFF for more than 24 hours (if your rt has had the FCTN set to OFF for more than 24 hours, reset all FH sync time functions). The clock immediately stops running when FCTN is set to STW or Z- A. a. b. NEVER confuse FH sync time with wristwatch time. CHECKING FH SYNC TIME Set FCTN to SQ ON. Press three times. Each press gives you a different display. The first press displays the days (last two digits of Julian date). The second press displays hours and minutes. The third press displays minutes and seconds. SETTING FH SYNC TIME If rt FCTN is set to Z-A, all time functions must be set manually or by ERF from NCS. To manually set all functions (days, hours, minutes), do the following steps: o Obtain net’s time standard. I-13

Privacy Statement
Press Release
Contact