TM 5-2420-224-20-2
CRANE REPLACEMENT (CONT)
4.
REMOVE two snap rings (7) and pivot PIN (8) on left side crane mounting.
NOTE
It may be necessary to use tilt control lever to take pressure off tilt cylinder pin.
5.
REMOVE two snap rings (9) and tilt cylinder PIN (10) and DISCONNECT tilt CYLINDER (11).
6.
START ENGINE, RETRACT tilt CYLINDER (11), and DISENGAGE crane LOCKS.
7.
MOVE VEHICLE FORWARD 6-10 in. (15-25 cm) to gain access to hydraulic hose quick disconnects
(12 and 13). STOP ENGINE and DISENGAGE PTO (TM 5-2420-224-10).
8.
RELIEVE PRESSURE FROM HYDRAULIC SYSTEM (page 2-23) and DISCONNECT quick
DISCONNECT (12) from connector (14).
9.
DISCONNECT quick DISCONNECT (13) from connector (15).
4-778