TM 5-2420-224-20-2
TIE ROD ADJUSTMENT
This task covers: Adjustment
INITIAL
SETUP
Tools and Special Equipment:
General Safety Instructions:
Tool Kit, SC 5180-90-CL-N26
Personnel Required: (2)
Make sure wheels are properly
chocked to prevent roll off and
possible injury to personnel.
NOTE
Front wheels are considered centered when measurement is taken from inside front
wheel to chassis on both sides and both measurements are equal.
1.
Place vehicle on flat, level surface and center front wheels.
NOTE
Following measurement must be taken at wheel center height.
2.
Measure from forward inside edge of rim A of one wheel to forward inside edge of wheel A on
opposite side of vehicle. Record measurement.
3.
Measure from rear inside edge of rim B of one wheel to rear inside edge of wheel B on opposite side
of vehicle. Record measurement.
4-341
