TM 55-4920-413-13&P
CHAPTER 3
OPERATING INSTRUCTIONS
Section I. OPERATOR’S CONTROLS AND INDICATORS
3-1. Operator’s Controls.
All operator’s controls and indicators are shown in
Figure 3-1 and listed and described in Table 3-1.
Section II. OPERATION UNDER USUAL CONDITIONS
3-2. Preliminary Starting Procedure.
3-3. Procedures for Shutdown.
a. Place all test set switches to OFF, NOR, or LO.
a. Press ROTOR OVERSPEED RESET to reset
rotor overspeed warning indicators.
b. Connect test set as shown in Figure 2-2.
b. Place all test set switches to OFF, NOR, or LO.
c. Do an operational check (TM 55-1520-237-23-3).
c. Disconnect cable assemblies.
3-1
