TM 55-4920-413-13&P
Table 3-1. Operator’s Controls (Cont)
Control, indicator or connector
GAS GEN SPEED NO. 2
NOR CAL switch
HI LO switch
Variable control
HIGH OIL TEMP NO. 1
HIGH OIL TEMP NO. 2
ENGINE OUT NO. 1
ENGINE OUT NO. 2
ENGINE % RPM NO. 1
NOR CAL switch
HI LO switch
Variable control
ENGINE % RPM NO. 2
NOR CAL switch
HI LO switch
Variable control
TORQUE NO. 1
NOR CAL switch
HI LO switch
Variable control
TORQUE NO. 2
NOR CAL switch
HI LO switch
Variable control
Function
Permits selection of mode of operation for equipment testing
of Ng #2 indicator.
Permits selection of high and low calibration tests for Ng #2
indicator when NOR CAL switch is placed to CAL.
Used to check range of operation of Ng #2 indicator when
NOR CAL switch is placed to NOR.
Used to indicate simulated conditions which exist on appropriate
parameter tests.
Used to select mode of operation: normal or calibration of
% RPM #1 indicator.
Used to select high and low speed calibration points of
% RPM #l indicator when NOR CAL switch is placed to CAL.
Used when NOR CAL switch is placed to NOR, to check
operation of % RPM Engine #l indicator over its range.
Selects mode of operation for % RPM #2 indicator - normal or
calibration.
Used to select high and low calibration points for % RPM #2
indicator when NOR CAL switch is placed to CAL.
Used when NOR CAL switch is placed to NOR, to check
operation of % RPM #2 indicator over its range.
Used to select mode of testing - normal or calibration of
% TRQ #1 indicator.
Permits selection of high and low calibration of % TRQ #1
indicator checks when NOR CAL switch is placed to CAL.
Permits testing of range of operation of the % TRQ #1 indica-
tor system when NOR CAL switch is at NOR.
Used to select mode of testing - normal or calibration of
% TRQ #2 indicator.
Permits selection of high and low calibration checks of
% TRQ #2 indicator when NOR CAL switch is placed to CAL,
Permits testing of range of operation of % TRQ #2 indicator
system when NOR CAL switch is at NOR.
3-5
