TM 5-2420-224-20-2
CRANE TRAVEL LOCK REPLACEMENT AND ADJUSTMENT (CONT)
I N S T A L L A T I O N
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
IF REMOVED, INSTALL new BUSHING (1) and new lubrication FITTING (2).
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
INSTALL
mounting BRACKET (3), two capscrews (4), and two new lock nuts (5).
MOUNT (6), four capscrews (7), and four nuts (8).
SPRING (9) in mounting bracket (3).
CONTROL assembly (10) all the way into mounting bracket (3).
ADAPTER (11) on control assembly (10) and TIGHTEN NUT (12).
PIN (13) and pin (14) on control assembly (10).
PIN (13) in mounting bracket (3).
CONTROL assembly
spring PIN (16).
new tiedown STRAP
(10) in rear of mounting bracket (3) and TIGHTEN NUT (15).
(17).
BRACKET (18), two bolts (19), and two nuts (20).
INSTALL CONTROL assembly (10) in bracket (18).
INSTALL two NUTS (21 and 22).
INSTALL KNOB (23) on control assembly (10).
1.
2.
3.
4.
5.
6.
Place crane in transport position (TM 5-2420-224-10).
Make sure pin (1) is completely engaged in crane latch
NOTE
bail (2).
Perform step 3 only if pin is not completely engaged in crane latch bail. If completely
engaged, go to step 4.
Loosen nut (3) to extend pin (1) into crane latch bail (2). Tighten nut (4).
Make sure pin (1) is completely disengaged from crane latch bail (2) when placing crane in upright
position.
NOTE
Perform step 5 only if pin does not completely disengage.
Loosen nut (4) and pull pin (1) back enough to completely disengage. Tighten nut (3).
Repeat steps 1 thru 5 until adjustments are achieved.
4-788
A D J U S T M E N T