TM 5-2420-224-20-2
BACKHOE STABILIZER CYLINDER REPLACEMENT (CONT)
1.
2.
3.
4.
DISCONNECT two HOSES (1 and 2). lNSTALL CAPS or PLUGS.
REMOVE two retaining rings (3) and ROD (4).
REMOVE two retaining rings (5), pin (6), and stabilizer CYLINDER (7).
REMOVE clamp (8), TUBE (9), two fittings (10 and 11), and two packings (12 and 13) from stabilizer
cylinder. INSTALL CAPS or PLUGS. DISCARD PACKINGS.
I N S T A L L A T I O N
NOTE
Procedure is the same for both stabilizer cylinders.
1.
REMOVE CAPS or PLUGS. INSTALL two fittings (10 and 11), two new packings (12 and 13), TUBE
(9), and clamp (8) on stabilizer cylinder (7).
2.
INSTALL stabilizer CYLINDER (7), pin (6), and two retaining rings (5).
3.
INSTALL ROD (4) and two retaining rings (3).
4.
REMOVE CAPS or PLUGS. CONNECT two HOSES (1 and 2).
NOTE
Follow-on Maintenance:
Check rear hydraulic tank (LO 5-2420-224-12).
4-674
