TM 5-2420-224-20-2
BACKHOE/CRANE TILT CYLINDER REPLACEMENT (CONT)
1.
DISCONNECT two hydraulic HOSES (1 and 2). INSTALL CAPS or PLUGS.
2.
REMOVE four snap rings (3 and 4), two pins (5 and 6), and tilt CYLINDER (7).
3.
REMOVE two FITTINGS (8 and 9) and two packings (10 and 11). DISCARD PACKINGS.
I N S T A L L A T I ON
NOTE
Procedure is the same for both vehicles.
1.
INSTALL two new packings (10 and 11) and two FlTTINGS (8 and 9).
2.
INSTALL tilt CYLINDER (7), two pins (5 and 6), and four snap rings (3 and 4).
3.
REMOVE CAPS or PLUGS. CONNECT two hydraulic HOSES (1 and 2).
NOTE
Follow-on Maintenance:
Check front hydraulic tank (LO 5-2420 -224-1 2).
4-676
