TM 5-2420-224-20-2
BACKHOE SWING CONTROL PEDAL ADJUSTMENT
This task covers:
Adjustment
I N I T I A L S E T UP
Applicable Configuration:
Equipment Condition:
SEE
Reference
Condition
Tools and Special Equipment:
Page 2-22
Backhoe in Three-Point
Stance
TooI Kit, SC 5180-90-CL-N26
Page 4-404
Backhoe Control Tower
Materials/Parts:
Removed
Pin, Cotter
1.
2.
3.
4.
5.
NOTE
Adjust either or both control pedals.
Make sure control valve spool is in neutral position.
Make sure control pedals are even and have enough movement to fully actuate valve.
Remove cotter pin (1) and pin (2) from control rod (3) and shaft (4). Discard cotter pin.
Back off nut (5) and turn clevis (6), as needed, for proper length.
Install pin (2) through control rod (3) and shaft (4).
Perform steps 1 thru 3, as needed, for proper adjustment.
When adjustment is complete, tighten nut (5) and install new cotter pin (1).
NOTE
Follow-on Maintenance:
install backhoe control tower (page 4-404).
4-522
