TM 5-2420-224-20-2
BACKHOE SWING CONTROL PEDAL REPLACEMENT (CONT)
NOTE
If needed, adjust control pedals at this time (page 4-522).
5.
INSTALL COVER (12), three washers (13), and three new self-tapping screws (14) in control tower
(15).
6.
ROTATE two outer control LEVERS (16) OUTWARD from center and TIGHTEN two NUTS (17).
7.
INSTALL five KNOBS (18) on five control levers (16).
8.
INSTALL grease FITTING (19) in bracket (20).
9.
CONNECT tilt CYLINDER (21) and install pin (22) and two retaining rings (23).
NOTE
Follow-on Maintenance:
Install backhoe seat (page 4-444).
4-521
