TM 11-5895-1412-12&Pb.c.d.e.f.g.h.i.j.k.l.00000SetSetSetLockout set(s), if needed.Hopset(s).If display shows “L7” or “L8”, you are missing mandatorylockout set(s).MAN channel frequency.CUE channel frequency.Load TEK and KEK as required (see BASIC COMSEC PROCEDURES).DURING OPERATIONCHAN to position where hopset is stored.COMSEC to CT (if required).FCTN to LD, MODE to FH.Monitor CHAN position where hopset is stored and acknowledgecommunication;On command, pressPress <CLR>.Enter the numberspress <STO> untiltwo times (display shows “00 00”).for new hours and minutes on the keyboard. Do notNCS gives command.Stand by for NCS command to store hours and minutes.On command, press <STO>.It is extremely important that you do not press<STO> until the NCS tells you to (you may lose net communication).Set FCTN to SQ ON (or normal operating position).Confirm communication with NCS.o If you cannot establish communication, monitor MAN channel and wait.The NCS comes back to you.NOTE: When shutting down, only set FCTN to STBY if you want to save FH data.FH UPDATE USING FRFThis procedure is used to update hopsets and loperations.It is also used to add new sets.communicates on the FH channel it has been usiFH Update Procedure.The following steps areDetailed NCS procedures are provided in manualNOTE: Do not changea.Set FCTN to LD.ockout sets during netDuring an update, the netng.designed for net members.TM 11-5820-890-10-1.the CHAN setting until all updating is complete.Leave all other controls as they have been for pastcommunications.b.The NCS contacts you. Acknowledge call.NCS tells you which channel tostore data in, and to confirm reception and storage of ERF after it isfinished.J-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
