TM 5-2420-224-20-2
BACKHOE ASSEMBLY REPLACEMENT (CONT)
9.
10.
11.
EXTEND tilt CYLINDER (9) to aline with
mounting eye and ENGAGE backhoe lock
CYLINDERS.
NOTE
Insert tapered end of pin first.
CONNECT tilt CYLINDER (9) by INSTALLING
PIN (10) and two snap rings (11).
NOTE
Use stabilizers and backhoe to
assist in alining holes for pin
installation.
Insert tapered end of mounting
pins first.
INSTALL two mounting PINS (12) and four
snap rings (13).
12. INSTALL BOX (4) and four screws (3).
13. INSTALL two WIRES (2) and two nuts (1)
and CAREFULLY ROLL rubber BOOTS OVER
connection.
NOTE
Follow-on Maintenance:
Install rear composite stoplight/
taillight (page 4-190).
Install work light (page 4-186).
Install backhoe subframe deck
(page 4-362).
Check rear hydraulic tank (LO 5-
2420-224-12).
4-759