TM 5-2420-224-20-2
B A C K H O E A S S E M B L Y R E P L A C E M E N T ( C O N T)
W A R N I N G
V e h i c l e m a y m o v e w h e n
b a c k h o e m o u n t i n g p i n s a re
removed resulting in possible
injury to personnel.
NOTE
Stabilizers may be used to relieve
pressure on mounting pins.
3.
REMOVE four snap rings (5) and two
mounting PINS (6).
W A R N I N G
Support tilt cylinder. Failure to
do so could result in injury to
personnel.
4.
D I S C O N N E C T t i l t C Y L I N D E R ( 7 ) by
REMOVING two snap rings (8) and PIN (9).
5.
START ENGINE. RETRACT tilt CYLINDER (7)
from mounting eye and DISENGAGE backhoe
lock CYLINDERS.
6.
PULL TRACTOR FORWARD 6 to 10 in. and
SHUT OFF ENGINE.
NOTE
Tag all lines prior to disconnecting
to aid in connecting.
7.
RELIEVE HYDRAULIC PRESSURE (page
2-23) and DISCONNECT hydraulic HOSE
(10).
4-755
