TM 32-5895-248-14&P
INTRODUCTION
Section I. GENERAL
1-1 SCOPE. This manual provides instructions for installa-
1-4 ADMINISTRATIVE STORAGE. Administrative stor-
tion and operation of the Data Analysis Central AN/TYQ-5
age shall be in accordance with instructions provided in TM
( c e n t r a l ) under usual and unusual conditions. The manual
740-90-1, Administrative Storage of Equipment.
also contains operator/crew, organizational, direct support,
and general support maintenance instructions and
i n c l u d e s cleaning and inspection, troubleshooting, parts
1 - 5 C A L I B R A T I O N . No
calibration of
the equipment in
replacement, and repair of the central. A repair parts and
the central is required.
special tools list, including depot level parts, is also
provided.
1-6 REPORTING EQUIPMENT IMPROVEMENT REC-
m e n t of the Army forms and procedures used for equip-
O M M E N D A T I O N S (EIR'S). If your central needs improve-
ment maintenance will be those prescribed by TM 38-750,
ment let us know. Send us an EIR. You, the user, are the
the Army Maintenance Management System (TAMMS).
only one who can tell us what you don't like about your
e q u i p m e n t . Let us know why you don't like the design.
1-3 DESTRUCTlON OF ARMY MATERIEL TO PRE-
Tell us why a procedure is hard to perform. Put it on an SF
V E N T E N E M Y U S E . The central shall be destroyed to
368 (Quality Deficiency Report). Mail it to us at US Army
prevent enemy use in accordance with instructions provided
E l e c t r o n i c s Materiel Readiness Activity, ATTN: SELEM-
in TM 750-244-2, Procedures for Destruction of Electronics
ME-I, Vint Hill Farms Station, Warrenton, Virginia 22186.
M a t e r i e l to Prevent Enemy Use (Electronics Command).
We'll send you a reply.
Section Il. DESCRIPTION AND DATA
position consists of an upper cabinet assembly, a bulletin
1-7 PURPOSE AND USE.
The Data Analysis Central AN/
board, a work surface, and? lower cabinet assembly.
b. A map board assembly is mounted on the left wall
portable facility used to extinct and analyze data obtained
from intercepted radio signals. The central can be used as a
of the shelter as you look at the face of the center console.
c. A n a d j u s t a b l e w o r k s u r f a c e i s p r o v i d e d f o r u s e
s i n g l e unit configuration or as a part of an Operational
Unit, Transportable System (OUTS).
between the two corner consoles that face the center
console.
d. Each of the five work positions has a rotary chair
1-8 Description. The Data Analysis Central AN/TYQ-5
with an associated tiedown assembly.
can be installed on a 2--ton or larger vehicle for opera-
e. T h e c o m p o n e n t s o f t h e c e n t r a l t o w h i c h c o m m o n
tion as a single unit. It can also be mounted on a V-398
names are assigned are shown in table 1-1. A tabular listing
trailer when used as part of the OUTS.
of major and minor components is contained in table 1-2.
D e t a i l e d descriptions of the components are provided in
the following paragraphs. Locations of the components
a. T h e c e n t r a l i s e q u i p p e d w i t h f i v e w o r k s t a t i o n s
(four corner consoles and one center console). Each work
are shown in figure FO-1.