TM 11-7021-202-12
CHAPTER 3
OPERATOR'S MAINTENANCE
3-1.
GENERAL
This chapter provides the Operator's maintenance instructions and procedures for Data
Processing Set AN/UYK-64 (V). Operator Maintenance is limited to cleaning and replacing
fuses.
3-2.
LUBRICATION
No lubrication or lubricants are required.
3-3.
CLEANING
The following cleaning procedure is to be performed by the Operator as required.
(1)
Remove dust and dirt from exterior surfaces using a clean, lint-free cloth
(item 3, appx E).
Isopropyl alcohol is extremely flammable; use
in well ventilated area away from fire, sparks,
or any other heat source. When not in use,
keep alcohol container closed.
(2)
Remove grease using a clean, line-free cloth (item 3, appx E) soaked with
isopropyl alcohol (item 1, appx E). Wipe dry using a clean, lint-free cloth.
(3)
Use a bristle brush (item 2, appx E) to remove dirt from hard to reach areas.
Verify that the ETM indicator appears to be operating.
(4)
Remove caked-on dirt using a bristle brush (item 2, appx E) soaked with
(5)
isopropyl alcohol (item 1, appx E). Wipe dry using a clean, lint-free cloth
(item 3, appx E).
3-1
