TM 11-5805-424-15/NAVELEX 0967-220-9010/TO 31W2-2G-41
and pull the module straight out from the chassis. To
replace, insert it into the chassis, and secure it to the
(3) Clean the air filter (para 4-1c) or obtain a
chassis with the hexagonal nuts.
replacement air filter and reposition the air filter
b. Air Filter.
on the rear of the front panel.
(1) Remove the power supply submodule (a (1)
(4) Secure the air filter with the screws, washers,
above).
and nuts. Be sure the screws are securely
tightened.
(2) Remove the screws, washers, and nuts that
secure the air filter to the rear of the front panel
(5) Replace the power supply submodule (a (1)
and remove the air filter.
above).
c. Rf Gaskets. Rfi gaskets must be replaced as a
Caution: Be careful not to damage
single piece. Before replacing an rfi gasket, be sure the
the rfi gasket cemented to the air
surface is thoroughly cleaned to insure electrical
filter if the air filter is to be cleaned
continuity. Tighten all screws securely to insure good
and replaced.
electrical continuity.
4-7
