TM 5-2420-224-20-2
CRANE VERTICAL OUTRIGGER CYLINDER REPLACEMENT (CONT)
1.
2.
3.
4.
5.
DISCONNECT two hydraulic HOSES (1).
INSTALL CAPS or PLUGS.
REMOVE two BOLTS (2) holding leg
assembly (3) to arm (4) and REMOVE LEG
assembly (3).
REMOVE PIN (5) holding rod end of vertical
outrigger cylinder (6) to leg (7) and REMOVE
LEG (7).
REMOVE two FITTINGS (8) and two packings
(9). DISCARD PACKINGS.
REMOVE two BOLTS (10) holding vertical
outrigger cylinder
REMOVE vertical
from sleeve (11).
I N S T A L L A T I O N
(6) to sleeve (11) and
outrigger CYLINDER (6)
1.
2.
3.
4.
5.
NOTE
Procedure is the same for both
vertical outrigger cylinders.
INSTALL two new packings (9) and two
FITTINGS (8).
INSTALL vertical outrigger CYLINDER (6) in
sleeve (11) and INSTALL two BOLTS (10).
INSTALL LEG (7) and pin (5) through rod end
of vertical outrigger cylinder (6).
INSTALL LEG assembly (3) on arm (4) and
INSTALL two BOLTS (2).
REMOVE CAPS or PLUGS. CONNECT two
hydraulic HOSES (1).
NOTE
Follow-on Maintenance:
Check rear hydraulic tank (LO 5-
2420-224-12).
4-701