TM 5-2420-224-20-2
FORKLIFT TILT CYLINDER REPLACEMENT
This task covers:
a. Removal b. Installation
Applicable Configuration:
General Safety Instructions:
HMMH
Tools and Special Equipment:
Shop Equipment, SC 4910-95-CL-A74
TOOI Kit, SC 5180-90-CL-N26
Materials/Parts:
Washer, Lock
Caps and Plugs
Rags
References:
TM 5-2420-224-10
LO 5-2420-224-12
Equipment Condition:
Reference
TM 5-2420-224-10
Page 2-23
Appendix C, Item 7
Appendix C, Item 32
Condition Description
Forklift Lowered to
Ground
Hydraulic Pressure
Relieved
W A R N I N G
High pressure hydraulics [oil
under 2450 psi (16,893 kPa)]
o p e r a t e t h i s e q u i p m e n t .
N e v er
d i s c o n n e c t
a n y
h y d r a u l i c l i n e o r f i t t i n g
w i t h o u t
f i r s t
d r o p p i ng
p r e s s u r e t o z e r o . A h i g h
p r e s s u r e o i l s t r e a m c a n
p i e r c e b o d y a n d c a u s e
severe injury to personnel.
Fuel and oil are slippery and
c a n c a u s e f a l l s . T o a v o id
injury, wipe up spilled fuel or
oil with rags.
R E M O V A L
C A U T I O N
Cap or plug all ports and ends of hoses and tubes to prevent contamination
of hydraulic oil. Failure to do so may result in damage to equipment.
NOTE
Procedure is the same for both tilt cylinders.
Tag lines prior to disconnecting to aid in connecting.
1.
DISCONNECT two HOSES (1 and 2). INSTALL CAPS or PLUGS.
4-686
