TM 5-2420-224-20-2
FORKLIFT REPLACEMENT (CONT)
W A R N I N G
Tractor front wheels must be in
line with forklift assembly prior
to installation. If there is any
contact between front wheels
and forklift, reposition vehicle.
Failure to do so could result in
injury to personnel.
NOTE
Stands may have to be adjusted
to allow vehicle to go under forklift
assembly mounting bracket.
4.
CAREFULLY ALINE VEHICLE with forklift
assembly (3) and MOVE VEHICLE under
frame (5).
5.
REMOVE CAPS or PLUGS. CONNECT three
hydraulic HOSES (6).
6.
TURN tilt cylinder shutoff VALVE (7) to OPEN
position.
7.
LOWER STANDS simultaneously until forklift
assembly (3) is mounted on frame saddle (8).
8.
INSTALL two new lock washers (2) and two
mounting SCREWS (1). TIGHTEN SCREWS
to 750 Ib-ft (1016.9 N.m).
4-552
