TM 5-2420-224-20-2
FORKLIFT REPLACEMENT (CONT)
6.
TILT MAST (7) FORWARD until tips of forks
(3) firmly contact ground and rear of forks (3)
are approximately 4 in. (10 cm) off ground.
7.
8.
9.
10.
11.
TURN tilt cylinder shutoff VALVE (8) to
CLOSED position.
RELIEVE HYDRAULIC PRESSURE (page
2-23).
LOWER forklift STABILIZERS (9) to within
approximatelv 4 in. (10 cm) of around and
INSTALL PINS.
C A U T I O N
Cap or plug all ports and ends
of hoses and tubes to prevent
contamination of hydraulic oil.
Failure to do so may result in
damage to equipment.
NOTE
Tag lines prior to disconnecting to
aid in connecting.
DISCONNECT three hydraulic HOSES
INSTALL CAPS or PLUGS.
(10).
DISCONNECT electrical CONNECTOR (11).
4-548