TM 5-2420-224-20-2
B R A K E S Y S T E M B L E E D I N G ( C O N T )
3.
Install adapter assembly (5) to two brake fluid
reservoirs (3 and 4).
C A U T I O N
Air supply must be regulated to
14.5-29.0
psi
(1-2
bar)
to
prevent damage to equipment.
4.
Connect adapter assembly (5) to air supply
hose (6).
C A U T I O N
Brake fluid is to be considered
contaminated and is not to be
reused to prevent damage to
equipment.
NOTE
Use suitable container to catch
brake fluid.
Open only one bleeder valve at
a time.
Observe fluid level in brake
fluid reservoirs and do not allow
brake fluid to go below MIN
indication before adding more
fluid to reservoir.
Brake system is considered
p r o p e r l y b l e d w h e n s t e a d y
stream of brake fluid comes out
of bleeder valve with no air
bubbles in the stream.
5.
Bleed brake system in following order:
a.
b.
c.
d.
f .
g.
h.
i.
Master cylinder (7) 2 places
Right rear caliper (8)
Left rear caliper (9)
Right rear front caliper (10)
Left rear front caliper (11)
ALB modulator (12)
Right front caliper (13)
Left front caliper (14)
Clutch slave cylinder (15)
4-263
e.