TM 11-7021-202-12
f . Package and pack the defective unit in accordance with instructions provided in
chapter 5.
g. Forward defective unit to Direct Support Maintenance.
INSTALLING PROCESSOR
4-15.
WARNING
The processor is a heavy piece of equipment.
Always use three technicians when moving or
lifting the unit to prevent injury to personnel.
Remove unit from the packing and packaging in which it was received. File
a.
documents (i. e., reports, tags, etc.) that accompanied the unit.
Remove dust caps from the connectors on the unit. Remove dust caps from the
b.
cables to be connected up to the unit.
Position the processor in its operating location (rack-mount or counter-top
c.
configuration).
WARNING
Turn off power before working on equipment.
Failure to do so can cause serious injury to
personnel.
Connect power cable to processor (para 4-17).
d.
Connect I/O cabling to the processor in accordance with the cabling diagram
e.
requirements listed and shown in the system manual (para 4-19). If applicable,
connect ground strapping/cabling in accordance with requirements of system
manual.
Ensure that airflow around installed unit is not restricted in any way.
f.
Connect power cable to prime power source. Refer to paragraph 2-7 for
g.
turn-on procedures.
h.
Perform Preventive Maintenance Checks and Services (PMCS). Refer to
chapter 2.
Bring the unit on line with the system in accordance with the instructions
i.
contained in the system manual.
4-15
