TM 11-7440-278-14
f.
Column 6, Remarks. Column 6 contains an
column 3. This figure represents the active time required
to perform that maintenance function at the indicated
alphabetic code which leads to the remark in section IV,
category of maintenance. If the number or complexity of
Remarks, which is pertinent to the items opposite the
the tasks within the listed maintenance function vary at
particular code.
different maintenance categories, appropriate "work
time" figures will be shown for each category. The
D-4.
Tool and Test Equipment Requirements (Sect
number of taskhours specified by the "work time" figure
III)
represents the average time required to restore an item
a. Tool or? Test Equipment Reference Code.
(assembly, subassembly, component, module, end item
The numbers in this column coincide with the numbers
or system) to a serviceable condition under typical field
used in the tools and equipment column of the MAC.
operating conditions. This time includes preparation time,
The numbers indicate the applicable tool or test
troubleshooting time, and quality assurance/quality
equipment for the maintenance functions.
control time in addition to the time required to perform
b. Maintenance Category. The codes in this
the specific tasks identified for the maintenance
column indicate the maintenance category allocated the
functions authorized in the maintenance allocation chart.
tool or test equipment.
Subcolumns of column 4 are as follows:
c. Nomenclature. This column lists the noun
C - Operator/Crew
name and nomenclature of the tools and test equipment
0 - Organizational
required to perform the maintenance functions.
F - Direct Support
d. National/NATO Stock Number. This column
H - General Support
lists the National/NATO stock number of the specific tool
D - Depot
or test equipment.
e. Column 5, Tools and Equipment. Column 5
e. Tool Number-.
This column lists the
specifies by code, those common tool sets (not individual
manufacturer's part number of the tool followed by the
tools) and special tools, test, and support equipment
Federal Supply Code for manufacturers (5-digit) in
required to perform the designated function.
parenthesis.
D-5.
Remarks (Sect IV) Not applicable.
(Next printed page is D-3)
D-2
