TM 11-7440-278-14
APPENDIX B
COMPONENTS OF END ITEM LIST
Section I. INTRODUCTION
(2) Item, number. The number used to
B-1.
Scope
identify item called out in the illustration.
This appendix lists integral components of and Basic
b. National Stock Number.
Indicates the
issue items for the AN/MYK-8(V) (*) to help you inventory
National stock number assigned to the item and which
items required for safe and efficient operation.
will be used for requisitioning.
c. Part Number. Indicates the primary number
B-2.
General
used by the manufacturer, which controls the design and
characteristics of the item by means of its engineering
This Component of End Items is divided into the
drawings, specifications, standards, and inspection
following sections:
requirements to identify an item or range of items.
a.
Section II. Integral Components of the End
Following the part number, the Federal Supply Code for
Item. Not applicable. These items, when assembled,
Manufacturers (FSCM) is shown in parentheses.
comprise the AN/MYK-8(V) (*) and must accompany it
d. Description. Indicates the Federal item
whenever it is transferred or turned in. The illustrations
name and, if required, a minimum description to identify
will help you identify these items.
the item.
b. Section III.
Basic Issue Items.
Not
e. Location. The physical location of each
applicable. These are the minimum essential items
item listed is given in this column. The lists are designed
required to place the AN,/MYK-8(V) (*) in operation, to
to inventory all items in one area of the major item before
operate it, and to perform emergency repairs. Although
moving on to an adjacent area.
shipped separately packed they must accompany the
f.
Usable on Code. Not applicable. "USABLE
AN,/MYK-8(V) (*) during operation and whenever it is
ON" codes are included to help you identify which
transferred
between accountable officers.
The
component items are used on the different models.
illustrations will assist you with hard-to-identify items.
Identification of the codes used in these lists are:
This manual is your authority to requisition replacement
BII, based on TOE/MTOE authorization of the end item.
Code
Used on
g. Quantity Required (Qty Reqd).
This
B-3.
Explanation of Columns
column lists the quantity of each item required for a
complete major item.
a.
Illustration.
This column is divided as
h. Quantity. This column is left blank for use
follows:
during an inventory. Under the Rcvd column, list the
(1) Figure number. Indicates the figure
quantity you actually receive on your major item. The
number of the illustration on which the item is shown.
Date columns are for your use when you inventory the
major item at a later date; such as for shipment to
another site.
(Next printed page is B-3)
B-1
