TM 11-7440-232-12/NAVELEX 0967-LP-275-5010
APPENDIX B
COMPONENTS OF END ITEM AND BASIC ISSUE ITEMS LIST
Section I. INTRODUCTION
B-1. SCOPE
This appendix lists components of end item and basic issue items for the MD-701(*)/UY to help you inventory items
required for safe and efficient operation.
B-2. GENERAL
The Components of End Item and Basic Issue Items Lists are divided into the following sections:
a. Section II. Components of End Item. This listing is for informational purposes only, and is not authority to
requisition replacements. These items are part of the end item, but are removed and separately packaged for
transportation or shipment. As part of the end item, these items must be with the end item whenever it is issued or
transferred between property accounts. Illustrations are furnished to assist you in identifying the items.
b. Section III. Basic Issue Items. These are the minimum essential items required to place the MD-701(*)/UY in
operation, to operate it, and to perform emergency repairs. Although shipped separately packaged BII must be with the
MD-701(*)/UY during operation and whenever it is transferred between property accounts. The illustrations will assist you
with hard-to-identify items. This manual is your authority to request/requisition replacement BII, based on TOE/MTOE
authorization of the end item.
B-3. EXPLANATION OF COLUMNS
a. Illustration. This column is divided as follows:
(1) Figure number. Indicates the figure number of the illustration on which the item is shown.
(2) Item number. The number used to identify item called out in the illustration.
b. National Stock Number. Indicates the National stock number assigned to the item and which will be used for
requisitioning.
c. Description. Indicates the Federal item name and, if required, a minimum description to identify the item. The
part number indicates the primary number used by the manufacturer, which controls the design and characteristics of the
item by means of its engineering drawings, specifications, standards, and inspection requirements to identify an item or
range of items. Following the part number, the Federal Supply Code for Manufacturers (FSCM) is shown in parentheses.
d. Location. The physical location of each item listed is given in this column. The lists are designed to inventory all
items in one area of the major item before moving on to an adjacent area.
e. Usable on Code. Not applicable.
f. Quantity Required (Qty Reqd). This column lists the quantity of each item required for a complete major item.
g. Quantity. This column is left blank for use during an inventory. Under the Rcvd column, list the quantity you
actually receive on your major item. The Date columns are for your use when you inventory the major item.
B-1
