TM 11-5895-1412-12&P
APPENDIX C
COMPONENTS OF END ITEM LIST
C-1 .
This
Battl
for s
C-2 .
Section I.
INTRODUCTION
Scope
appendix lists integral components of and basic issue Items for the
efield Electronic CEOI System (BECS) to help you inventory items required
afe and efficient operation.
General
This Components of End Item List is divided into the following sections:
a.
Section II.
Integral Components of the End Item. These items, when
assembled, comprise the BECS and must accompany it whenever it is transferred
or turned in.
The illustrations will help you identify these items.
b. Section III.
Basic Issue Items.
These are the minimum essential
items required to place the BECS in operation, to operate it, and to perform
emergency repairs.
Although shipped separately packed they must accompany
BECS during operation and whenever it is transferred between accountable
officers.
The illustrations will assist you with hard-to-identify items.
This manual is your authority to requisition replacement BII, based on
TOE/MTOE authorization of the end item.
C-3. Explanation of Columns
a.
Illustration.
This column is divided as follows:
(1) Figure number.
Indicates the figure number of the illustration
on which the item is shown.
(2) Item number.
The number used to identify item called out in
the illustration.
b. National Stock Number.
Indicates the National stock number assigned
to the item and which will be used for requisitioning.
c.
Description.
Indicates the Federal item name and, if required, a
minimum description to identify the item.
The part number (when applicable)
indicates the primary number used by the manufacturer, which controls the
design and characteristics of the item by means of its engineering drawings,
specifications,
standards, and inspection requirements to identify an item or
range of items.
Following the part number, the Federal Supply Code for
Manufacturers (FSCM) (as applicable) is shown in parentheses.
d.
Location.
The physical location of each item listed is given in this
column.
The lists are designed to inventory all items in one area of the
major item before moving on to an adjacent area.
e.
Usable on Code USABLE ON codes are included to help you identify
which component items are used on the different models.
C-1