B R A K E M A S T E R C Y L I N D E R R E P L A C E M E N T ( C O N T )
SET parking BRAKE.
Tag lines prior to disconnecting to aid in connecting.
Have suitable container available to catch brake fluid.
DISCONNECT brake fluid reservoir HOSE (1) and clutch hydraulic reservoir HOSE (2). DRAIN each
HOSE into suitable container.
USING WRENCH, DISCONNECT two brake line FITTINGS (3 and 4).
REMOVE three screws (5), three spring tension washers (6), and brake master CYLINDER (7).
DISCARD spring tension WASHERS.
REMOVE two bleeder VALVES (8 and 9).
I N S T A L L A T I ON
INSTALL two bleeder VALVES (8 and 9).
INSTALL brake master CYLINDER (7), three screws (5), and three new spring tension washers (6).
USING WRENCH, CONNECT two brake line FITTINGS (3 and 4).
CONNECT two HOSES (1 and 2).
Fill clutch hydraulic reservoir (LO 5-2420-224-1 2).
Fill brake fluid reservoir (LO 5-2420-224-12).
Bleed brake system (page 4-262).
Adjust brake pedal (page 4-287).
Install outside engine hood (page 4-388).
R E M O V A L